Hunan Yibeinuo New Material Co., Ltd.
products
News
Home > News >
Company News About What We Checked Before Shipping a Ceramic-Lined Reducer
Events
Contacts
Contacts: Miss. Amy
Fax: 86-731-8639-6190
Contact Now
Mail Us

What We Checked Before Shipping a Ceramic-Lined Reducer

2026-11-19
Latest company news about What We Checked Before Shipping a Ceramic-Lined Reducer

A photo taken straight into the large end of a ceramic-lined reducer shows the pattern of alumina tiles. A raised tile edge halfway down the cone is harder to spot from that angle. ELACERA inspected the tile joints, the taper and both pipe connections before packing the reducer for a cement raw meal line in Indonesia.


Where the cut tiles meet

As the cone narrowed, we cut tiles to fit its changing circumference. Before packing, we checked ceramic coverage where the cut pieces met. When reviewing a close-up, follow a seam to its widest point. A chipped corner can leave the backing exposed to powder even when the rest of the seam is narrow. If your drawing specifies a maximum joint width, ask for the measured gap and a photo with a scale at that spot.


Checking the taper in the direction of flow

The large end was the inlet on this reducer. We checked how smoothly each tile row met the next in the direction the raw meal would travel. Even a narrow joint can have a step. If a downstream tile sits higher than its upstream neighbor, its edge faces the incoming powder and takes the impact.


For a remote inspection, ask for a photo taken at a shallow angle along the taper, with the flow direction marked. On a flat-bottom eccentric reducer, include a view along the flat side so the installer can see whether the lining forms a continuous floor.


The last row at each pipe end

At the inlet and outlet, we checked the ceramic edges, the finished passage and the orientation of the connections. Ask for a photo taken square-on to each opening before packing. Compare the last row with the approved drawing. If it calls for a steel end ring or a setback, the ceramic may stop short of the connection face by design.


To verify the fit with the adjoining pipe, ask for the measured inside diameter at each end, taken between opposite ceramic faces. If an end ring narrows the opening further, record its clear bore as well. For the dimensions to compare on the two mating parts, see our ceramic-lined reducer drawing checklist.


What to put on the purchase order

“Please identify the part and drawing revision on the inspection record. For each end, list the specified finished bore, tolerance and measured bore on the same line. Include a photo of each opening and an angled view along the taper before packing.”


For a replacement quote, mark the finished bore at each end, the end-to-end length and the flow direction on a drawing or sketch. Include the material conveyed and the quantity you need, then email it to Amy@ybnceramic.com.


View the flat-bottom eccentric reducer with alumina tile lining